High Flow Fuel Hand Pump Portable Manual Siphon Transfer Tool for Car Gasoline Petrol Diesel Oil Liquid Water Fish Tank

✅【Hand Water Siphon Pump】

High-flow hoses and large-bore ball pumps are faster at pumping, and the built-in pump allows you to siphon liquid from one container to another. Whether you need to transfer fuel, petrol, diesel, gasoline, oil, or even water, this liquid syphon hand pump is up for the task.

✅【Faster Transfer】

Syphon pump for gasoline, hard-wearing and non-slip, for fast and efficient siphoning of liquids. It can start siphoning liquid in 5 seconds, which takes 60 seconds or more than older models. The siphon hose for gasoline delivers 3.5 gallons of liquid per minute, making the job easy and time-saving.

✅【Nice Materials】

Made with durable PVC material, this siphon pump for water is built to last. The syphon hose for gas is made of thick PVC transparent hose, which is wear-resistant and durable. Weighing in as a lightweight and compact manual pump, this device is designed for convenience.

✅【Upgraded】

The newly upgraded design of the siphon hand pump does not require a buckle, which is more convenient to use, and there is no need to worry about the trouble of the buckle breaking and rusting in the later stage. Whether you need to transfer fuel, petrol, diesel, gasoline, oil, or even water, this pump is up for the task.

✅【Warming Use Tip】

The arrow on the squeeze ball of gas syphon hand pump indicates the direction of liquid flow, helping you to transfer the liquid in the correct flow direction. Simply connect the hoses and utilize the built-in pump to effortlessly siphon liquid from one container to another.

✅【Wide Applications】

Lightweight and portable hand pump siphon, suitable for gasoline, oil, diesel, water. It is suitable for all kinds of vehicles, motorcycles, boats, lawn mowers, brush cutters, hedge trimmers, etc. without anti-theft filters.

Parameters: 

✅ Type: Hand Fuel Pumps

✅ Vehicle Service Type: Car

✅ Material: Rubber

✅ Position: Upper

✅ Note: The fluid you are trying to extract has to be HIGHER than the influent bucket. The fitting end must kept inside of the fluid not just on the surface.